PowerMaster is a new blasting system that operates with compressed air and water-soluble blasting agents. If necessary, small amounts of water are additionally dosed and added. The new cleaning process is based on an environmentally friendly and water-soluble granulate, which is introduced into a compressed air stream. Just before exiting, the granulate is moistened with water to increase kinetic energy. Due to the soft granulate, metallic surfaces are not affected, and other surfaces are minimally or not affected at all. Compressed air consumption starts from 2 m³/min at 2-8 bar pressure. Water consumption starts from 0.50 l/min. Granulate consumption depends on the application. PowerMaster can also be used in an automated version.
PowerMaster is used, for example, for cleaning and coating removal of pipes (inner and outer surfaces), rods, strips, profiles, and wires. The system operates cost-effectively in the low-pressure range between 3 and – depending on the system type – a maximum of 8 bar of compressed air, with low water consumption ranging from 0.5 to 2 liters per minute. Depending on the application, the blasting speed can be in the subsonic or supersonic range.
When using the blasting agents recommended by mycon, even polished stainless steel surfaces or light metal surfaces can be cleaned or coated without visible damage to the metal surfaces. Films, paints, varnishes, resins, fats, bituminous layers, or release agents on molds can be removed gently, quickly, and economically with PowerMaster. PowerMaster can also be used for cleaning and coating removal of plastic surfaces.
The possibilities of using PowerMaster: PowerMaster can be used for cleaning large surfaces with special nozzles up to 160 mm wide. When removing lighter contaminants, PowerMaster works with the addition of extremely gentle blasting agents. Vehicles, vehicle rims, as well as glass, plastics, or building facades of any kind can be cleaned intensively and gently at high surface performance.
After Cleaning
Before Cleaning
PowerMaster Innovation
PowerMaster cleans, decoats and desizes in a powerful and low-waste process.The cost-effective system operates at low pressure between 3 and – depending on the type of system – a maximum of 8 bar compressed air at a low water consumption of 1 to 2 litres per minute. Depending on the application, the jet velocity can be in the subsonic or supersonic range.
When using the blasting abrasives recomended by mycon, even polished stainless steel surfaces or light metal surfaces ca be cleaned or decoated without visible impairment of the metal surfaces. Foils, paints, varnishes or resins, greases, bituminous layers or release agents on moulds can be removed getly, quickly and economically with PowerMaster. PowerMaster can also be used for plastic surfaces.
