scope

Waste incineration plants

Maximizing the thermal efficiency of Luko systems

Waste incineration plants operate under extreme thermal loads. In warm months, dirty air-cooled condensers can significantly reduce system performance. mycon offers advanced, water-saving cleaning technologies specifically designed to restore the full thermal efficiency of heat exchangers, condensers and air preheaters - without generating quantities of wastewater.

Combating efficiency losses

Data shows that capacitor performance can plummet to 57% in just 5 months (April to August). This pollution causes a decrease in combustion capacity of 5.6% and a loss of electricity production of 7.9%. Conventional high-pressure water purification forces systems offline for extended periods of time and produces unmanageable amounts of contaminated wastewater.

Recommended products

Patented cleaning systems for air-cooled heat exchangers and tube bundle heat exchangers.

JetMaster & AS (Automated)TubeMaster

Restoration of heat transfer

mycon cleaning systems also clean stubborn combustion residues.

Air preheater cleaning

Large quantities of particle-laden air flow through air preheaters. Over time, residue builds up on the outside surfaces of the pipe, reducing airflow and heat transfer. The JetMaster combination system also removes nasty hard deposits without roughening the outside pipe surfaces

Cleaning sensitive graphite tubes

Graphite shell and tube heat exchangers are often used in corrosive environments such as waste incineration plants. However, the graphite itself is brittle. Cleaning must be carried out at low pressure to avoid damage to the graphite tubes. The TubeMaster uses compressed air and special blasting media to remove hard dirt from the pipes without causing any damage.